Lightly used 250 Volt Wire Welder. I used it for auto body and 18 to 316 thick mild steel hobby work. Comes with Lincoln cart paid around $200 for cart and gas hose regulator setup. Also comes with two partial rolls of .030 wire, and an almost full roll of .030 Flux Core wire. I think the rolls are all 3lb size. Does not come with a Gas Cylinder.
Miller CP-200 ARC WELDER 3 Phase S-22A Speed Wire Feeder Gun Serial KE612232.Cart and chains for tanks included. Came from working inviorment.Only have whats in the picturesSorry I have no way to test.
$1,500

tig Welder

over a month agoBeaufort, SCTools for Sale
I have had this welder for a while has not been used for 15 yrs . it dusty as it hasnt move in years . has wheels cart. long coolant line . reg and helmet Cash, no checks unless from local banks and can be verified
over a month agoBeaufort, SCTools for Sale
Up for sale is a slightly used Lincoln Ranger 250 welder. It also comes with a stinger50and ground cable50. Also will throw in an auto dark welders mask. 931 Eight 07-1101Please reply with your PhoneCell number for more update.
over a month agoBeaufort, SCTools for Sale
Up for sale is a slightly used Lincoln Ranger 250 welder. It also comes with a stinger50and ground cable50. Also will throw in an auto dark welders mask. 931 Eight 07-1101Please reply with your PhoneCell number for more update.
Similar
over a month agoBeaufort, SCCars for Sale
Im selling a 2004 Dodge Ram 3500 dually with the 5.9l Cummins. The only reason for selling is the I went into a traveling inspection job and Im not going to use it. THIS IS A COMPLETE WELDING RIGGuaranteed money makerOn the truck is a custom welding bed that just needs to get sand blasted and painted quoted about $500. 2 hours of sand blast with primer and rhino line. On the bed is a 1994 Linco...
over a month agoLaurel Bay, SC+8 milesFurniture for Sale
This table is brand new bought a few years ago. Only used a few times. Since I was pregnant I could no longer give massages. This is a $400 massage table. I am only selling it cheap because since the last time I used it I probably did not clip the leg down all the way and 1 of them broke off. I took a picture. If you know a welder it can be fixed. My lost your gain. fcfs. pickup on laurel bay o...
I have wanted a Ducati for quite some time, and in July 2015 I took the plunge and picked up a 95 M-900. The test ride went good and it needing a fork seal and starter solenoid was no big deal, as part of the point was a project to do with the kids. After getting it home I found a few more things the bike needed; rear brakes, speedo cable, and a crack at the left front engine mount. I did some ...